Challenge Five - Motors, gearboxes and wheels
One red M-M jumper into the red side of the connector and one black M-M jumper into the black side of the connector.
Battery and snap connector
Blue jumper from the transistors connect into the blue jumper from the motors.
Both black jumpers from the transistors into the black power rail.
Arduino 5v pin to one of the yellow terminal strips
Both yellow jumpers from the light sensors to the same yellow terminal strip as the 5v Arduino jumper.
Green jumpers from the light sensors into A0 & A1 Arduino pins
Green jumpers from the transistors into the digital 3 & 5 pins.
Red jumpers from the motors into the red power rails.
Black jumpers from the light sensors to the black power rails.
Arduino barrel jack into the red and black power rails.
Both transistors set up with green, blue and black M-F jumpers.

This site uses cookies to deliver our services. By using our site, you acknowledge that you have read and understand our Terms of Service and Cookie Policy. Your use of ThingLink's Products and Services, is subject to these policies and terms.